WORKSHOP ORGANIZATION · BEGINNER
How to make a workshop marker parking rack with vibe CAD
Park capped workshop markers horizontally with their labels visible. Open saddles locate the barrels without gripping the caps, while unequal channel widths accommodate round, square and oversized marker bodies in one drawer insert.
Concept illustration. Customize the prompt and upload your CAD.
A dry-storage rack for capped markers, not a spill-control or ink-preservation product.
01 / START WITH THE REAL OBJECT
Measure before you prompt.
- Capped length and widest barrel section of each marker.
- Cap diameter and clip projection.
- Available drawer footprint and closed height.
- Finger space needed to lift the shortest marker.
State units. If a dimension is missing, have your agent ask for it.
02 / GIVE YOUR AGENT A CLEAR BRIEF
Copy this into your CAD conversation.
Use Claude or another agent with a CAD tool such as OpenSCAD, CadQuery or your existing modeler. Fill in your measurements and keep the source editable.
Create a horizontal marker rack with marker_lengths, barrel_widths, cap_widths, clip_reliefs, saddle_spacing and channel_clearance. Ask for missing measurements and each marker's preferred storage orientation. Use open rounded saddles under the barrels and leave caps and clips clear. Add a short saddle coupon. Do not design an uncapped ink holder, cap seal or pressure-fit retention mechanism.03 / INSPECT AS YOU BUILD
Model it in deliberate steps.
Map the capped markers
Place the markers horizontally with labels facing up. Measure the barrel, cap and pocket clip as separate features rather than assuming one uniform cylinder.
Create paired saddles
Put two low supports beneath the body of each marker. Adjust spacing to avoid seams, tapered sections or label ridges that would make the marker rock.
Add removal space
Leave an open area beside the barrel for fingers. Keep the front edge below the caps so a marker can be lifted without pulling against its closure.
04 / VALIDATE THE FIRST PROTOTYPE
Check the fit and intended use.
- Review a saddle coupon for the largest and smallest barrel profiles.
- Inspect the layout for clearance around cap clips.
- Compare the assembled marker height with the closed drawer reference.
Material
PLA or PETG can be explored for the rack.
List critical dimensions and acceptable deviations in your request. See clearance and fit and material grades.
05 / START YOUR ORDER
Upload your CAD. Get an exact quote.
Customize the prompt, export your model and submit it with quantity, intended use and fit requirements. We review your request and send a nonbinding quote; the payment link follows if you accept.
No charge at submission. Current firm print scope is PLA/PETG shipped within the contiguous US/DC.