WORKSHOP ORGANIZATION · INTERMEDIATE
How to make a drill bit index tray with vibe CAD
Lay detached drill bits in separate labeled channels so their sizes are easy to find. The tray locates each bit around its smooth shank and leaves extra room around the cutting end, without becoming a drill guide or sharpening fixture.
Concept illustration. Customize the prompt and upload your CAD.
A stationary organizer for detached bits.
01 / START WITH THE REAL OBJECT
Measure before you prompt.
- Overall length and shank diameter of each bit.
- Maximum width across the cutting end.
- Number of bits and available drawer footprint.
- Space needed to grasp the smooth shank.
State units. If a dimension is missing, have your agent ask for it.
02 / GIVE YOUR AGENT A CLEAR BRIEF
Copy this into your CAD conversation.
Use Claude or another agent with a CAD tool such as OpenSCAD, CadQuery or your existing modeler. Fill in your measurements and keep the source editable.
Create a detached drill-bit storage tray with bit_lengths, shank_diameters, tip_widths, channel_clearance, shank_support_height and label_height. Ask for missing measurements and the labeling units. Use open channels with shallow shank saddles and enlarged noncontact tip recesses. Add finger access only beside the shanks. Do not model drill bushings, cutting guides or a transport-retention mechanism.03 / INSPECT AS YOU BUILD
Model it in deliberate steps.
Record tool envelopes
Measure each detached bit's total length and widest cutting section separately from the shank. Arrange the set with all shanks facing the same accessible edge.
Create shank supports
Place two low saddles beneath the smooth portion of each bit. Keep the cutting end over a wider relief area rather than resting it against a narrow wall.
Add indexing
Label the shank end of each channel. Leave enough spacing for lifting one bit without reaching between neighboring cutting ends.
04 / VALIDATE THE FIRST PROTOTYPE
Check the fit and intended use.
- Review a saddle coupon against one measured shank before repeating the pattern.
- Inspect sections for clearance around the widest cutting geometry.
- Compare the complete layout with the drawer's actual usable depth.
Material
PLA or PETG can be considered for the tray.
List critical dimensions and acceptable deviations in your request. See clearance and fit and material grades.
05 / START YOUR ORDER
Upload your CAD. Get an exact quote.
Customize the prompt, export your model and submit it with quantity, intended use and fit requirements. We review your request and send a nonbinding quote; the payment link follows if you accept.
No charge at submission. Current firm print scope is PLA/PETG shipped within the contiguous US/DC.