WORKSHOP ORGANIZATION · BEGINNER
How to make a sanding sheet divider with vibe CAD
Separate flat sanding sheets by grit inside an existing storage box. Thin labeled divider plates keep the groups visible while allowing the sheets to lie flat, with rounded lower corners that match the box rather than creasing the abrasive paper.
Concept illustration. Customize the prompt and upload your CAD.
A storage divider, not an abrasive tool
01 / START WITH THE REAL OBJECT
Measure before you prompt.
- Stored sheet width and length after the usual cutting pattern.
- Box inside width, depth and closed height.
- Thickness of the largest sheet group.
- Readable label-tab height above the stored sheets.
State units. If a dimension is missing, have your agent ask for it.
02 / GIVE YOUR AGENT A CLEAR BRIEF
Copy this into your CAD conversation.
Use Claude or another agent with a CAD tool such as OpenSCAD, CadQuery or your existing modeler. Fill in your measurements and keep the source editable.
Design sanding-sheet dividers with sheet_width, sheet_length, box_width, divider_thickness, corner_radius, tab_height and tab_offsets. Ask for missing dimensions and the grit groups to label. Use plain smooth plates with rounded corners and staggered tabs. Keep the dividers loose in the box, and show representative sheet stacks as reference bodies. Do not make a sanding block or working abrasive attachment.03 / INSPECT AS YOU BUILD
Model it in deliberate steps.
Standardize the storage orientation
Choose whether sheets stand on an edge or lie in separated stacks. Measure the actual cut sizes used in the workshop, including irregular offcuts kept separately.
Draw the divider outline
Match the box's available width while leaving a measured removal allowance. Round corners where the box floor curves upward.
Stagger the tabs
Move successive tabs along the top edge so their grit labels remain visible. Keep raised lettering off the broad faces that contact the sheets.
04 / VALIDATE THE FIRST PROTOTYPE
Check the fit and intended use.
- Try paper divider outlines with the real sheets and box.
- Check the tallest tab against the closed-box height.
- Verify the label order matches the user's actual grit groups.
Material
PLA is an option for dry indoor storage.
List critical dimensions and acceptable deviations in your request. See clearance and fit and material grades.
05 / START YOUR ORDER
Upload your CAD. Get an exact quote.
Customize the prompt, export your model and submit it with quantity, intended use and fit requirements. We review your request and send a nonbinding quote; the payment link follows if you accept.
No charge at submission. Current firm print scope is PLA/PETG shipped within the contiguous US/DC.