SMALL ELECTRONICS · INTERMEDIATE
How to make a small speaker desktop cradle with vibe CAD
Position a small enclosed desktop speaker using an open cradle that leaves its grille, controls, cable connections and existing openings visible.
Concept illustration. Customize the prompt and upload your CAD.
A passive desktop holder, not an acoustic accessory with demonstrated performance or a protective equipment mount.
01 / START WITH THE REAL OBJECT
Measure before you prompt.
- Measure the speaker housing and identify the intended contact surfaces.
- Locate the grille, controls, existing openings, feet and connector removal paths.
- Choose a listening orientation with a cardboard side-profile mockup.
- Measure the available desk footprint and a removable housing gap.
State units. If a dimension is missing, have your agent ask for it.
02 / GIVE YOUR AGENT A CLEAR BRIEF
Copy this into your CAD conversation.
Use Claude or another agent with a CAD tool such as OpenSCAD, CadQuery or your existing modeler. Fill in your measurements and keep the source editable.
Create an open speaker cradle with housing_profile, body_width, tilt_angle, contact_regions, grille_keepout, opening_keepouts and housing_gap. Use low side guides and an unobstructed front. Ask for the actual housing outline and every existing opening. Do not claim acoustic improvement, vibration isolation or protective performance.03 / INSPECT AS YOU BUILD
Model it in deliberate steps.
Define the orientation
Sketch the housing at the chosen angle and mark the grille and control areas. Keep the front lip below any surface that must remain accessible.
Place limited contact areas
Create a base and short guides on measured clear housing regions. Avoid covering existing feet, openings or cable paths simply to make the cradle symmetrical.
Add removal access
Cut a broad finger opening and round contact corners. Keep the housing as a separate reference so later angle changes can be checked for new collisions.
04 / VALIDATE THE FIRST PROTOTYPE
Check the fit and intended use.
- Use a cardboard profile with the speaker switched off to review orientation, control access and desk footprint.
- Inspect the assembly from front, sides and rear to confirm the grille and existing openings remain clear.
- Check the export scale and plan a short housing-profile sample before assuming the full cradle fits.
Material
PLA or PETG may be considered for a geometry sample.
List critical dimensions and acceptable deviations in your request. See clearance and fit and material grades.
05 / START YOUR ORDER
Upload your CAD. Get an exact quote.
Customize the prompt, export your model and submit it with quantity, intended use and fit requirements. We review your request and send a nonbinding quote; the payment link follows if you accept.
No charge at submission. Current firm print scope is PLA/PETG shipped within the contiguous US/DC.