PHOTOGRAPHY · BEGINNER
How to make a photo white card stand with vibe CAD
Position a small white or gray reference card beside a tabletop subject. Two low stands hold the card at a chosen angle, allowing repeatable placement without attaching anything to a camera or relying on printed color accuracy.
Concept illustration. Customize the prompt and upload your CAD.
A holder for a small lightweight card, not a lighting stand or camera support.
01 / START WITH THE REAL OBJECT
Measure before you prompt.
- Reference card width, height and thickness.
- Desired viewing angle relative to the tabletop.
- Space available beside the photographed object.
- Maximum stand width that stays out of the frame.
State units. If a dimension is missing, have your agent ask for it.
02 / GIVE YOUR AGENT A CLEAR BRIEF
Copy this into your CAD conversation.
Use Claude or another agent with a CAD tool such as OpenSCAD, CadQuery or your existing modeler. Fill in your measurements and keep the source editable.
Create a pair of small photo-card stands with card_thickness, slot_clearance, slot_depth, card_angle, foot_length and foot_width. Ask for missing dimensions and whether the card has a sleeve. Make broad low feet with a loose angled slot and a finger relief. Include a slot coupon. The printed part positions an existing card; it is not itself a calibrated color or exposure reference.03 / INSPECT AS YOU BUILD
Model it in deliberate steps.
Mock up the card angle
Use folded paper to hold the actual card in the intended photograph. Record the angle and mark positions where the stands will remain outside the composition.
Model the locating slot
Create a short slot around the actual card thickness. Add a rounded entry and keep the contact region below the card's visible reference area.
Review the feet
Extend the base around the leaning card in side view. Keep both stands identical and leave room to adjust their spacing along the lower edge.
04 / VALIDATE THE FIRST PROTOTYPE
Check the fit and intended use.
- Review a slot coupon before choosing final clearance.
- Check that the stand does not obscure the reference area's usable surface.
- Compare the footprint and card angle with the paper mockup.
Material
PLA is an indoor prototype option.
List critical dimensions and acceptable deviations in your request. See clearance and fit and material grades.
05 / START YOUR ORDER
Upload your CAD. Get an exact quote.
Customize the prompt, export your model and submit it with quantity, intended use and fit requirements. We review your request and send a nonbinding quote; the payment link follows if you accept.
No charge at submission. Current firm print scope is PLA/PETG shipped within the contiguous US/DC.