PLANT CARE · INTERMEDIATE
How to make a nesting spacer for empty plant pots with vibe CAD
Keep two matching empty nursery pots from wedging together during storage. Three small tabs on a loose ring establish a visible gap between their rims, based on the actual taper and nesting depth.
Concept illustration. Customize the prompt and upload your CAD.
A proposed separation aid for two empty pots only; no stacking capacity is established.
01 / START WITH THE REAL OBJECT
Measure before you prompt.
- Outer diameter beneath the upper pot's rim.
- Inner diameter of the lower pot at the nesting depth.
- Current nesting overlap and desired removal gap.
- Rim shape and available finger access.
State units. If a dimension is missing, have your agent ask for it.
02 / GIVE YOUR AGENT A CLEAR BRIEF
Copy this into your CAD conversation.
Use Claude or another agent with a CAD tool such as OpenSCAD, CadQuery or your existing modeler. Fill in your measurements and keep the source editable.
Model a loose nesting spacer for two empty lightweight nursery pots. Use ring_diameter, ring_width, tab_height, tab_width, tab_count and fit_clearance. Ask for missing dimensions and both pot profiles. Use three broad spacing tabs with rounded ends and leave finger access between them. Do not design for filled pots, tall stacks or structural support; include one tab-and-ring coupon.03 / INSPECT AS YOU BUILD
Model it in deliberate steps.
Measure the nesting position
Place the two empty pots together without pressing them in. Mark where their rims approach and where fingers can separate them.
Create the spacing ring
Draw a loose ring around the measured interface. Keep it removable and avoid a continuous deep skirt that could wedge like the pots themselves.
Add separated tabs
Distribute three short tabs around the ring. Preview both pots together and confirm that the tabs create the intended visible separation.
04 / VALIDATE THE FIRST PROTOTYPE
Check the fit and intended use.
- Review a single tab coupon against the empty-pot rim profile.
- Check the ring leaves room for fingers on opposite sides.
- Inspect the assembly section for unintended contact along the pot taper.
Material
PLA is a starting point for dry storage.
List critical dimensions and acceptable deviations in your request. See clearance and fit and material grades.
05 / START YOUR ORDER
Upload your CAD. Get an exact quote.
Customize the prompt, export your model and submit it with quantity, intended use and fit requirements. We review your request and send a nonbinding quote; the payment link follows if you accept.
No charge at submission. Current firm print scope is PLA/PETG shipped within the contiguous US/DC.