DESK · BEGINNER
How to make a desk business-card dispenser with vibe CAD
Arrange a small stack of business cards in an open-front holder that lets visitors lift one card without bending the entire stack.
Concept illustration. Customize the prompt and upload your CAD.
desktop card holder.
01 / START WITH THE REAL OBJECT
Measure before you prompt.
- Measure the largest card width and height, including any rounded or folded variants.
- Measure the thickness of the intended stack rather than multiplying a nominal paper thickness.
- Choose the display angle using a folded-paper mockup on the actual counter or desk.
- Measure a comfortable thumb opening and identify which printed area must remain visible.
State units. If a dimension is missing, have your agent ask for it.
02 / GIVE YOUR AGENT A CLEAR BRIEF
Copy this into your CAD conversation.
Use Claude or another agent with a CAD tool such as OpenSCAD, CadQuery or your existing modeler. Fill in your measurements and keep the source editable.
Build a business-card holder with card_width, card_height, stack_depth, display_angle, front_lip_height, thumb_opening and side_clearance. Provide an open top and broad rear support. Ask for card format, maximum stack and visible artwork margin before choosing dimensions. Keep side_clearance adjustable for a card-stock coupon.03 / INSPECT AS YOU BUILD
Model it in deliberate steps.
Lay out the visible card
Use a side sketch to position the card and front lip. Check that the lip stays below important text on the front design.
Make the stack pocket
Extrude the floor, back and side cheeks around the stack envelope. Leave the upper corners open so thicker or curled cards can be removed.
Open the pickup area
Subtract the thumb opening from the front wall and round its edges. Keep the opening broad enough to reach the last card at the bottom.
04 / VALIDATE THE FIRST PROTOTYPE
Check the fit and intended use.
- Place a printed card image over the CAD front view and verify that the lip does not cover contact details.
- Use actual cards in a paper mockup to check pickup access with a nearly empty stack.
- Inspect the pocket section and plan a short wall-spacing sample before assuming the full stack will slide freely.
Material
Choose PLA or PETG after considering the desired surface finish.
List critical dimensions and acceptable deviations in your request. See clearance and fit and material grades.
05 / START YOUR ORDER
Upload your CAD. Get an exact quote.
Customize the prompt, export your model and submit it with quantity, intended use and fit requirements. We review your request and send a nonbinding quote; the payment link follows if you accept.
No charge at submission. Current firm print scope is PLA/PETG shipped within the contiguous US/DC.